Milford hatchery to shut down in July

The Milford Fish Hatchery near Junction City will shut down for eight months beginning July 1 for repair.

Milford is one of the few warm-water, intensive-culture fish hatcheries in the country. However, like most working facilities, time and wear take their toll, and the high-tech facility is more than 20 years old.

This hatchery has special maintenance needs because 7,200 gallons per minute of water are pumped a half-mile to the facility from Milford Supply Lake, and an additional 4,000 gpm of groundwater is pumped 100 yards, all to fill the hatchery’s 24 raceways.

Waste must be pumped three-eighths of a mile to sewage lagoons. To complete these tasks, 25 motors and pumps with backup systems are employed. Additional systems are also required to maintain water quality.

The shutdown is part of a five-year plan begun in 2002 to repair much of the hatchery’s infrastructure. Already completed are repair and rehabilitation of the liquid oxygen system, water aeration towers and wells.

Also completed are installation of an alarm system, sewage lift station monitors/protectors and numerous pumps and motors.

The work starting in July will include replacement of raceway water and drain valves, replacing low-pressure air lines, modifying the waste drain system to handle peak use and conform to state regulations, meeting demands of the domestic water supply system (which has increased 10-fold since 1985), replacing electrical wiring and creating underground access to raceway valves.

The shutdown is expected to have a minimal effect on the state’s supply of fish because the work will begin after the bulk of Milford’s fish production for the year is complete.

Lost production will be made up at other state hatcheries at Farlington, Meade and Pratt, as well as contracts with private fish growers.

As time and funding allow, future plans for the hatchery include a new siphon line from Milford Reservoir, which would provide an efficient and reliable supply of high-quality water.

The Milford facility uses an intensive system in which eggs are hatched in small containers, and fish are grown in concrete raceways. More fish can be produced in less water, and the health of the fish can be monitored daily.

The 24 concrete raceways hold approximately 18,000 gallons of water. Each raceway has its own recirculation system in which about two-thirds of the water is completely exchanged every hour.

Fish species raised at Milford include walleye, sauger, saugeye, wiper, hybrid sunfish, channel catfish, blue catfish, largemouth bass, striped bass and paddlefish.